A mountain is basically composed of peaks, rocks, caves, ridges and so on. In the process of design and manufacture of rockery, such a rule should be followed. Only in this way can the rockery built up be more ornamental and conform to the rules of the mountain. So in the actual construction of the rockery, we should pay attention to these points.
Stability is a general term for the method of placing a large mountain stone on one or several large mountain stones. The method of placing a large mountain stone flat on one or more large mountain stones is called stability. Stability requires stability and can not be shaken; the instability of the lower right should be padded with small stones to tighten the brake. Generally, wide-Shaped or long-shaped rocks are chosen. This technique is mainly used in the places where the foot of the mountain is empty and the lower right side needs to be made eyes.
The horizontal connection between rocks and mountains is called connection. The shape of stubble and the grain of stone surface at the joints of hill and rock foundation should match each other as much as possible. If the joints can be seamed properly, it will be good, but in most cases, it can be done as long as they are basically identical. For different matching seams, appropriate stone brake should be selected to make them integrated. Sometimes longitudinal cracks or stone seams should be made for the need of modelling. At this time, the inner side should be connected well. The purpose of the connection is not only to achieve the integrity of the appearance of the rocks, but also to make the structure cohesive, so as to convey and bear the pressure uniformly. When one end of the rock is slapped, the rock at the other end of the rock should have a sense of force.
It refers to the vertical connection between rocks. The stubble can be flat or concave or convex, but it must be closely occluded without slipping. The jointed rocks should be connected according to the grain on the outside, or at least be divided into horizontal and vertical lines.
Taking two separated rocks as the base foot, making the top of the head close to each other, as if they were fighting, and placing a connecting stone between the two ends; or using the principle of bucket component, placing an arch-shaped rock on the two bottom footstones.
That is to say, beside a large rock, a small rock is carried like a bag on one's shoulder. In order to make full use of the stubble biting pressure, or to use the gravity of the rocks above to stabilize it, it is necessary to use steel wire or iron to fix the connection lightly and fixedly in the concealed place where the force is applied. Generally speaking, it is used in the case that the shape of the outline of rocks is too flat and there is no concave-convex change.
The above content is organized and published by Jinan Rockery Manufacturing Company. More relevant information can be consulted by clicking on our official website: http://www.lounge-f.com.